This dilution calculator solves C1V1 = C2V2 for whichever value you are missing: how much stock to take, how much you will end up with, or what concentration you will get. It also tells you how much diluent to add and the dilution factor, and works in any units, from molar and percent to mg/mL, as long as you keep them consistent. A second panel plans a serial dilution: give the stock concentration, the factor per step, the number of tubes and the volume each should hold, and it lists the transfer and diluent volumes with every tube's concentration. Labs can paste a list of dilutions with one value blank per row and each is solved at once. It is free, runs entirely in your browser, and nothing you enter is uploaded.
| Dilution | Stock (mL) | Diluent (mL) |
|---|---|---|
| 1:2 | 50 | 50 |
| 1:5 | 20 | 80 |
| 1:10 | 10 | 90 |
| 1:20 | 5 | 95 |
| 1:50 | 2 | 98 |
| 1:100 | 1 | 99 |
The amount of solute stays the same when you dilute: stock concentration × stock volume equals final concentration × final volume.
The final volume minus the stock volume. Taking 10 mL of stock for 100 mL final means adding 90 mL of diluent.
A series of equal dilutions in a row. Each tube is diluted by the same factor from the one before, so a 1:10 series gives 1:10, 1:100, 1:1,000 and so on.
Yes. Any unit works as long as C1 and C2 use the same unit.
No. All calculations run in your browser.
Simple dilutions use C1 × V1 = C2 × V2: enter any three values and the fourth is solved, with the diluent to add (V2 − V1) and the dilution factor (C1 ÷ C2). A final concentration higher than the stock is rejected, since that would be concentration rather than dilution. The units are whatever you name, as long as both concentrations share one and both volumes share another. Serial dilutions transfer volume ÷ factor from each tube into volume × (1 − 1/factor) of diluent, so tube n holds the stock ÷ factorⁿ. Batch mode reads rows with exactly one of c1, v1, c2 or v2 left blank and solves each.