This 4-point fabric inspection calculator scores rolls the way quality inspectors do. Log each defect's length (and position if you want the 4-points-per-yard cap), mark holes, and get the roll's penalty points, points per 100 square yards and per 100 m², and accept or reject against your buyer's limit. Paste an inspection sheet to score a whole lot of rolls at once.
| Points | Roll | Points / 100 yd² | At limit 40 |
|---|---|---|---|
| 9 | 100 yd × 60 in | 5.4 | Accept |
| 30 | 120 yd × 58 in | 15.5 | Accept |
| 56 | 80 yd × 60 in | 42.0 | Reject |
Each defect gets 1–4 points by length, and the total is normalised to points per 100 square yards.
Points × 3600 ÷ (yards inspected × width in inches).
40 points per 100 yd² is common, but buyers set their own limit, sometimes 20–28 for finer fabrics.
2 points up to 1 inch, 4 points above.
No. Everything is calculated in your browser.
Each defect scores by length as in ASTM D5430: up to 3 in = 1 point, over 3 to 6 in = 2, over 6 to 9 in = 3, over 9 in = 4; holes and openings score 2 up to 1 in and 4 above. No more than 4 points are charged in any one linear yard when defect positions are given. Points per 100 square yards = total points × 3600 ÷ (yards inspected × cuttable width in inches); per 100 m² multiplies by 1.196. The roll is accepted when the score is within the agreed limit (40 by default). Batch mode scores many rolls with defects listed per roll.