Sheet Metal Bend Allowance Calculator

This bend allowance calculator works out the flat blank for a sheet metal part. Enter the material thickness, inside bend radius and bend angle, choose a K-factor or let it estimate one, and it gives the bend allowance, bend deduction and outside setback. List the outside flange lengths and it gives the flat length for the whole part. Paste a parts list to calculate every blank. It runs in your browser.

2 mm sheet, 90° bend

Inside radiusK-factorBAOSSBBD
1 mm0.332.6083.0003.392
2 mm0.404.3984.0003.602
4 mm0.457.6976.0004.303
6 mm0.5010.9968.0005.004

When to use it

  1. Cut blanks for brackets, channels and boxes.
  2. Check a CAD flat pattern by hand.
  3. Set up a press brake job with a new material.
  4. Quote sheet metal parts from drawings.
  5. Teach fabrication students bend allowance.

How to Use

  1. Enter thickness, radius and angle.
  2. Set the K-factor or estimate it.
  3. List the outside flange lengths.
  4. Read BA, BD and flat length, or batch parts.

Features

  1. Bend allowance and deduction
  2. Outside setback
  3. Flat blank length
  4. K-factor estimate
  5. Parts batch
  6. 100% client-side

FAQs

What is the difference between bend allowance and bend deduction?

Bend allowance is the length of the neutral axis through the bend; bend deduction is what you subtract from the outside dimensions for each bend. BD = 2 × OSSB − BA.

What K-factor should I use?

About 0.33 for tight bends (R below T), 0.40–0.45 for typical bends and 0.50 for large radii. A test bend gives the true value for your tooling.

How do I find the flat length?

Add the outside flange lengths and subtract one bend deduction per bend. 50 + 30 mm with 2 mm steel, 2 mm radius and K 0.4 at 90° is 80 − 3.60 = 76.40 mm.

Does this work for angles other than 90°?

Yes, any angle between 0 and 180° measured as the bend angle.

Is anything uploaded?

No. Everything runs in your browser.

Technical Details

Bend allowance BA = bend angle in radians × (inside radius + K-factor × thickness). Outside setback OSSB = tan(angle ÷ 2) × (radius + thickness). Bend deduction BD = 2 × OSSB − BA. The flat blank length is the sum of the outside (mold-line) flange lengths minus one bend deduction per bend. The K-factor can be entered or estimated from the radius-to-thickness ratio (0.33, 0.40, 0.45 or 0.50) for air bending. Batch mode lists parts with their flange dimensions.

Calculators & Converters

Calculators & Converters

  • 3D Print Cost and Filament Calculator
  • STL Viewer and Volume Calculator
  • Recipe Scaler and Converter
  • Baker's Percentage and Hydration Calculator
  • Catering Quantity Calculator
  • Fertilizer (NPK) Calculator
  • Seed Rate and Plant Population Calculator
  • Spray Tank Mix Calculator