This weld metal calculator estimates how much filler metal a job needs. Choose the joint — fillet, single-V, double-V or square butt — enter the leg length or plate thickness, the groove angle and root gap, and the total weld length, and pick the process. It shows the weld metal weight, the electrodes or wire to buy after deposition losses, the approximate number of stick electrodes and the arc time. Paste a weld list from a drawing to total a fabrication. It runs in your browser.
| Leg | Area mm² | kg/m |
|---|---|---|
| 3 mm | 5.0 | 0.039 |
| 4 mm | 8.8 | 0.069 |
| 5 mm | 13.8 | 0.108 |
| 6 mm | 19.8 | 0.155 |
| 8 mm | 35.2 | 0.276 |
| 10 mm | 55.0 | 0.432 |
| 12 mm | 79.2 | 0.622 |
About 0.14 kg per metre (18 mm² × 7.85 g/cm³), or 0.155 kg/m with 10% reinforcement.
Stick electrodes lose their stub ends, flux and spatter; only about 60% ends up in the weld.
Weld metal ÷ deposition rate: stick deposits about 1–2 kg/h, MIG 2–5 kg/h.
Yes, as a percentage you set (10% by default).
No. Everything runs in your browser.
Weld cross-section: fillet = leg² ÷ 2; single-V butt = t² × tan(angle ÷ 2) + root gap × t; double-V halves the groove term; square butt = gap × t, plus a reinforcement allowance. Weld metal mass = area × length × 7.85 g/cm³. Consumables = weld metal ÷ deposition efficiency (stick electrodes about 60% including stubs and spatter, solid wire about 92%, flux-cored 82%, submerged arc 99%). Arc time = weld metal ÷ deposition rate. Batch mode reads a weld list.