Antenna Length Calculator

This antenna length calculator gives cutting lengths for common wire and whip antennas. Pick an amateur band or enter any frequency, and it shows the half-wave dipole length and each leg, the quarter-wave vertical, 5/8-wave and full-wave loop, and quarter- and half-wave lengths of your feedline for matching stubs, in metres or feet. Adjust the end-effect and velocity factors for your wire and coax. Paste a list of frequencies to plan several bands. It runs in your browser.

Half-wave dipole lengths (factor 0.95)

BandMHzDipole mDipole ftQuarter-wave m
80 m3.639.56129.819.78
40 m7.120.0665.810.03
20 m14.17510.0533.05.02
15 m21.2256.7122.03.35
10 m28.55.0016.42.50
6 m50.52.829.31.41

When to use it

  1. Cut a dipole for a ham band.
  2. Build a quarter-wave ground plane for 2 m.
  3. Make an FM broadcast or ADS-B receiving antenna.
  4. Cut a coax matching stub.
  5. Plan a multi-band wire antenna.

How to Use

  1. Pick a band or type a frequency.
  2. Adjust end-effect and velocity factors if needed.
  3. Read lengths in metres or feet.
  4. Paste a frequency list for several antennas.

Features

  1. Half-wave dipole and legs
  2. Quarter-wave and 5/8-wave
  3. Full-wave loop
  4. Feedline stub lengths
  5. Ham band presets
  6. Metres or feet
  7. Batch CSV

FAQs

How long is a 20 m dipole?

About 10.05 m (33 ft) in total for 14.175 MHz, or 5.02 m per leg.

Why is a dipole shorter than half a wavelength?

End effect and the wire's thickness make it resonate about 5% shorter; 0.95 is a common starting factor.

What is velocity factor?

Signals travel slower in coax than in free space; for stubs multiply the wavelength by the cable's factor, such as 0.66.

Should I cut exactly to length?

Cut slightly long and trim for the lowest SWR; height and surroundings shift resonance.

Is anything uploaded?

No. Everything runs in your browser.

Technical Details

Free-space wavelength λ = c ÷ f, which is 299.79 ÷ f(MHz) metres. A wire half-wave dipole is λ/2 multiplied by an end-effect factor of about 0.95, giving the familiar 143 ÷ f(MHz) m (468 ÷ f ft); each leg is half of that. Quarter-wave verticals, 5/8-wave whips and full-wave loops use the same factor. Matching stubs and phasing lines use λ × the feedline's velocity factor (0.66 for solid polyethylene coax, around 0.8–0.85 for foam). Batch mode reads a list of frequencies.

Electronics Tools

Electronics Tools

  • PoE Power Budget Calculator
  • Ohm's Law Calculator
  • Resistor Color Code Calculator
  • LED Resistor Calculator
  • Voltage Divider Calculator
  • Capacitor Code Calculator
  • Battery Life Calculator
  • UPS & Inverter Backup Time Calculator