Read a resistor's value from its color bands without memorizing the chart. Choose 4, 5 or 6 bands, pick the colors, and the calculator shows the resistance, the tolerance range and — for 6-band parts — the temperature coefficient, on a drawing of the resistor. Going the other way, type a value such as 4.7k and get the bands to look for. It runs in your browser.
| Color | Digit | Multiplier | Tolerance |
|---|---|---|---|
| Black | 0 | ×1 | — |
| Brown | 1 | ×10 | ±1% |
| Red | 2 | ×100 | ±2% |
| Orange | 3 | ×1k | ±0.05% |
| Yellow | 4 | ×10k | ±0.02% |
| Green | 5 | ×100k | ±0.5% |
| Blue | 6 | ×1M | ±0.25% |
| Violet | 7 | ×10M | ±0.1% |
| Gray | 8 | ×100M | ±0.05% |
| White | 9 | ×1G | — |
| Gold | — | ×0.1 | ±5% |
| Silver | — | ×0.01 | ±10% |
The end away from the tolerance band. Tolerance is usually gold, silver or brown and set slightly apart from the others. Gold and silver never appear as the first band.
In the multiplier position they mean ×0.1 and ×0.01, used for values under 10 Ω. In the tolerance position they mean ±5% and ±10%.
4-band resistors have two significant digits; 5-band have three, for precision values. A 6-band resistor adds a temperature coefficient showing how much the value drifts with temperature.
Yes. Enter the value in the lower panel. If it needs more significant figures than the band count allows, the tool rounds it and says so.
No. Everything is computed in the page.
A resistor's bands are read left to right with the tolerance band, which usually sits slightly apart, on the right. On a 4-band part the first two bands are significant digits; on 5- and 6-band parts the first three are. The next band is a power-of-ten multiplier from black (×1) to white (×10⁹), with gold and silver standing for ×0.1 and ×0.01 so that values under ten ohms can be marked. The tolerance band follows — gold ±5%, silver ±10%, brown ±1%, red ±2% and the tighter precision colors — and a 6-band resistor adds a temperature coefficient in parts per million per kelvin. Each band is constrained to the colors that are valid in its position, so an impossible combination cannot be selected. Decoding multiplies the significant digits by the multiplier and also shows the range the tolerance allows. Reverse mode takes a value, rounds it to the two or three significant figures the chosen band count can carry, and returns the bands; when rounding changed the value it says so, and it also reports the nearest E24 preferred value, since that is the part you can actually buy. All lookups are in the page; nothing is transmitted.