Voltage Divider Calculator

Work out a voltage divider's output from the input voltage and two resistors, or go the other way and find a pair of standard resistors for the output you need. The calculator shows the divider current and the power in each resistor, accepts values like 10k and 4k7, and draws the circuit so it is clear which resistor is which. It assumes no load on the output — a real load lowers it — and runs in your browser.

Divider formulas

QuantityFormula
Output voltageVout = Vin × R2 / (R1 + R2)
CurrentI = Vin / (R1 + R2)
Ratio for a targetR2 / R1 = Vout / (Vin − Vout)
Power in each resistorP = I² × R

When to use it

  1. Scale a 5 V signal down to 3.3 V for a microcontroller.
  2. Bring a battery voltage into an ADC's range.
  3. Set a reference or bias voltage.
  4. Pick real resistor values for a target ratio.

How to Use

  1. Enter the input voltage, R1 and R2.
  2. Read the output voltage, current and power.
  3. To design one, enter a target output and use the suggested resistors.

Features

  1. Output voltage, current and per-resistor power
  2. Best E24 pair for a target voltage
  3. SI prefixes and 4k7 notation
  4. Schematic showing R1 and R2
  5. Loading caveat stated
  6. 100% client-side

FAQs

Which resistor is R1?

R1 is between the input and the output; R2 is between the output and ground. Swapping them gives Vin minus the voltage you wanted.

Does it account for the load?

No — it is the unloaded divider. A load sits in parallel with R2 and lowers the output. Keep the load impedance at least ten times R2, or buffer the output with an op-amp.

How does it choose resistors for a target?

It tries every pair of E24 standard values with R1 between 1 kΩ and 100 kΩ and keeps the pair whose output is closest to your target, showing the remaining error.

Can I use a divider as a power supply?

Not usefully. The output sags as soon as current is drawn from it, and the divider wastes power continuously. Use a regulator.

Is my data sent anywhere?

No. All calculation is in the page.

Technical Details

Two resistors in series across a supply share its voltage in proportion to their values, so the voltage at the junction is Vout = Vin × R2 / (R1 + R2), with R2 the resistor to ground. The same current, Vin / (R1 + R2), flows through both, which gives each resistor's dissipation as I² × R. Values are entered with SI prefixes and converted to base units first. The reverse calculation takes an input voltage and a target output and searches every pair of E24 preferred values with R1 between 1 kΩ and 100 kΩ, keeping the pair whose output is closest to the target; that range keeps the divider current small without making the output so high-impedance that a measuring input disturbs it. The search is exhaustive rather than derived from the ideal ratio, because the best pair of real resistors is often not the one nearest the ideal ratio in either value. Every result is for an unloaded divider: anything connected to the output appears in parallel with R2 and pulls the voltage down, which is why the page recommends keeping the load at least ten times R2 or buffering it. Calculation happens in the page.

Electronics Tools

Electronics Tools

  • Capacitor Code Calculator
  • Battery Life Calculator
  • UPS & Inverter Backup Time Calculator
  • Solar System Sizer
  • Voltage Drop & Wire Size Calculator
  • Cable Ampacity and Derating Calculator
  • Conduit Fill Calculator
  • AWG to mm² Wire Gauge Converter