This duct size calculator works like a ductulator. Enter the airflow in CFM or L/s and choose equal friction (such as 0.08 in.wg per 100 ft) or a target velocity, and it gives the round duct diameter, an equivalent rectangular duct at your chosen aspect ratio, and the resulting velocity and friction rate. Paste a list of branch airflows to size a whole system. It runs in your browser.
| Airflow | Round diameter | Velocity |
|---|---|---|
| 100 CFM | 6.1 in | 497 fpm |
| 200 CFM | 7.9 in | 595 fpm |
| 400 CFM | 10.2 in | 711 fpm |
| 800 CFM | 13.1 in | 849 fpm |
| 1,200 CFM | 15.3 in | 942 fpm |
| 2,000 CFM | 18.5 in | 1,067 fpm |
About 10 in round at 0.08 in.wg per 100 ft, with a velocity near 710 ft/min.
0.08–0.10 in.wg/100 ft (0.65–0.8 Pa/m) is common for residential and light commercial systems.
Use the equivalent diameter De = 1.30(ab)^0.625/(a + b)^0.25; the tool solves it for your aspect ratio.
Flex has much higher friction; size it larger or use the maker's chart.
No. Everything runs in your browser.
Pressure loss per length uses Darcy–Weisbach with the Altshul–Tsal friction factor (f' = 0.11(ε/D + 68/Re)^0.25, adjusted below 0.018) for galvanised steel (ε = 0.09 mm) and standard air (1.204 kg/m³), as in ASHRAE Fundamentals. In equal-friction mode the round diameter whose loss equals the target rate is found by bisection; in velocity mode D = √(4Q/πv). The equivalent rectangle with a chosen aspect ratio matches the Huebscher diameter De = 1.30(ab)^0.625/(a + b)^0.25. Units: CFM and in.wg/100 ft (1 in.wg/100 ft = 8.17 Pa/m) or L/s and Pa/m.