Fence and Post Calculator

This fence calculator works out the materials for a timber or panel fence. Enter the total length, how many straight sides it has, the gates, the post spacing, rails per section and picket size, plus the post-hole size, and it gives the number of posts, sections or panels, rails, pickets and bags of concrete for the posts. Paste every side of a property to plan the whole boundary. It runs in your browser.

Posts for a single straight run

Length1.8 m spacing2.4 m spacing
10 m76
20 m1310
30 m1814
50 m2922

When to use it

  1. Plan a garden or boundary fence.
  2. Order posts and concrete for a panel fence.
  3. Count pickets for a picket fence.
  4. Price a fencing job by side.
  5. Compare 1.8 m and 2.4 m post spacing.

How to Use

  1. Enter fence length, sides and gates.
  2. Set post spacing, rails and picket size.
  3. Set the post-hole size and concrete bag yield.
  4. Read posts, rails, pickets and bags; paste sides for a whole site.

Features

  1. Posts with corners and gates
  2. Rails and pickets or panels
  3. Post-hole concrete in bags
  4. Batch CSV
  5. 100% client-side

FAQs

How many fence posts do I need?

Length ÷ post spacing, rounded up, plus one for each straight run, plus one per gate. 24 m at 2.4 m spacing in one run needs 11 posts.

How deep should fence posts go?

About a third of the post's height above ground, and below the frost line where that applies.

How much concrete per post?

The hole volume minus the post: a 250 mm hole 600 mm deep around a 100 mm post takes about 0.024 m³, roughly 2–3 bags of 20 kg.

How many pickets?

Fence length ÷ (picket width + gap).

Is anything uploaded?

No. Everything runs in your browser.

Technical Details

The fenced length (total minus gate widths) is divided by post spacing to give sections; each straight run needs one more post than it has sections, corners are shared, and each gate adds a post. Rails = sections × rails per section; pickets = fenced length ÷ (picket width + gap). Concrete per hole = π/4 × hole diameter² × depth − the post's own volume, totalled over all posts and converted to bags by the bag's yield. Batch mode reads one side per row.

Home & DIY Tools

Home & DIY Tools

  • Deck Calculator
  • Excavation and Trench Volume Calculator
  • Slope and Gradient Converter
  • Arch Radius from Chord Calculator
  • Water Tank Capacity Calculator
  • Pipe Rolling Offset Calculator
  • R-Value and U-Value Calculator
  • Bar Bending Schedule Maker