Compression Ratio Calculator

This compression ratio calculator works out an engine's static compression from the bore, stroke, head chamber volume, head gasket thickness and bore, piston-to-deck height, and piston dish or dome. Add the rod length and the cam's intake closing angle to see the dynamic compression ratio, which is what the engine actually sees and what matters for fuel octane and boost. Compare thinner and thicker gaskets, decking the block or different pistons side by side from a CSV. It runs in your browser.

Effect of gasket thickness (86 × 86 mm, 45 cc chamber, 87 mm gasket bore, 0.1 mm deck)

GasketClearanceStatic CR
0.5 mm48.6 cc11.3 : 1
0.8 mm50.3 cc10.9 : 1
1.0 mm51.5 cc10.7 : 1
1.3 mm53.3 cc10.4 : 1

When to use it

  1. Choose a head gasket thickness for a target compression.
  2. Check compression after skimming the head or decking the block.
  3. Pick pistons for a turbo or high-compression build.
  4. Check dynamic compression with a new camshaft.
  5. Compare several build options at once.

How to Use

  1. Enter bore and stroke.
  2. Enter the head chamber volume and piston dish (+) or dome (−).
  3. Enter the gasket bore and compressed thickness and the deck height.
  4. Read the static ratio; add rod length and intake closing for dynamic CR.

Features

  1. Static compression ratio
  2. Dynamic compression ratio
  3. Gasket, deck and piston volumes
  4. Dish or dome
  5. Compare options from CSV
  6. 100% client-side

FAQs

How is compression ratio calculated?

(Swept volume + clearance volume) ÷ clearance volume, where clearance is the head chamber, the gasket, the gap above the piston at top dead centre and any piston dish.

How do I enter a domed piston?

Enter the dome volume as a negative number of cc; a dish or valve reliefs are positive.

What is dynamic compression ratio?

Compression only starts when the intake valve closes, after bottom dead centre. Dynamic CR uses the stroke left at that point, so a longer-duration cam lowers it.

What deck height sign should I use?

Positive when the piston sits below the deck at top dead centre, negative when it pokes above.

Is anything uploaded?

No. Everything runs in your browser.

Technical Details

Swept volume per cylinder = π ÷ 4 × bore² × stroke. Clearance volume = head chamber + head gasket (π ÷ 4 × gasket bore² × compressed thickness) + deck volume (π ÷ 4 × bore² × piston-to-deck height) + piston dish or valve reliefs (a dome is negative). Static compression ratio = (swept + clearance) ÷ clearance. Optionally, dynamic compression uses the piston position when the intake valve closes, from rod length and the intake closing angle after bottom dead centre (x = r + l − (r cos θ + √(l² − r² sin² θ))), in place of the full stroke. Batch mode compares gasket, piston and deck options.

Calculators & Converters

Calculators & Converters

  • Horsepower, Torque and kW Calculator
  • Wheel Offset and Backspacing Calculator
  • Motorcycle Sprocket and Chain Calculator
  • 2-Stroke Fuel Mix Ratio Calculator
  • EV Charging Time and Cost Calculator
  • VIN Decoder and Check Digit Validator
  • Vehicle Running Cost per km Calculator
  • Metal Weight Calculator