Wheel Offset and Backspacing Calculator

This wheel offset calculator shows how a new set of wheels will sit compared with your current ones. Enter both wheels as width × diameter and ET offset, such as 7x17 ET45 and 8x17 ET35, and it shows how far the inner edge moves towards the suspension, how far the outer edge pokes out towards the arch, and the backspacing of each in millimetres and inches. Tyre shops can compare a whole list of candidate wheels from a CSV. It runs in your browser; test-fit before buying, because tyres, calipers and spacers change the real clearance.

Changes from a 7x17 ET45 wheel

New wheelInner edgeOuter edge
7x17 ET40−5.0 mm+5.0 mm
8x17 ET45+12.7 mm+12.7 mm
8x17 ET35+2.7 mm+22.7 mm
8.5x18 ET35+9.0 mm+29.1 mm
9x18 ET30+10.4 mm+40.4 mm

When to use it

  1. Check whether wider wheels will rub on the strut.
  2. See how much a lower offset will poke past the arch.
  3. Convert offset to backspacing for American wheel catalogues.
  4. Compare several wheel options for a car.
  5. Work out the spacer needed to match an old wheel's position.

How to Use

  1. Enter your current wheel, such as 7x17 ET45.
  2. Enter the new wheel.
  3. Read the inner and outer change and both backspacings.
  4. Paste a list of wheels to compare them all.

Features

  1. ET offset input
  2. Backspacing in mm and inches
  3. Inner clearance change
  4. Outer poke change
  5. Centre-line shift
  6. Batch CSV
  7. 100% client-side

FAQs

What is wheel offset (ET)?

The distance in millimetres from the wheel's centre line to its mounting face. Positive offset puts the mounting face toward the outside, tucking the wheel in; lower or negative offset pushes it out.

How is backspacing calculated?

Overall width ÷ 2 + offset, where overall width is about the rim width plus 1 inch. An 8-inch ET0 wheel has 4.5 inches of backspacing.

What happens if I go wider at the same offset?

Half the extra width goes inward and half outward. An inch wider moves each edge about 12.7 mm.

Does offset affect handling?

Changing offset moves the wheel centre line and changes the scrub radius, which can affect steering feel and kickback.

Is anything uploaded?

No. Everything runs in your browser.

Technical Details

A wheel is read as width × diameter with an ET offset in millimetres (8x17 ET35, 17x9 -12 or 8.5Jx18 ET35). Overall width is taken as rim width + 1 inch for the flanges. Backspacing = overall width ÷ 2 + offset, and front spacing = overall width − backspacing. Comparing a new wheel with the current one, the inner edge moves by the change in backspacing (positive is closer to the suspension) and the outer edge by the change in front spacing (positive pokes further out); the wheel centre line moves by the offset difference. Batch mode compares a list of wheels against the current one.

Calculators & Converters

Calculators & Converters

  • Motorcycle Sprocket and Chain Calculator
  • 2-Stroke Fuel Mix Ratio Calculator
  • EV Charging Time and Cost Calculator
  • VIN Decoder and Check Digit Validator
  • Vehicle Running Cost per km Calculator
  • Metal Weight Calculator
  • Beam Deflection and Bending Calculator
  • Bolt Torque and Preload Calculator