Motorcycle Sprocket and Chain Calculator

This motorcycle sprocket calculator shows what a gearing change does before you buy parts. Enter your current and new front and rear sprockets and see the final drive ratio, the percentage change, the speed at any RPM in top gear and how far the speedometer will be out. Add the chain size and the distance between sprocket centres to get the chain length in links. Compare a list of combinations at once from a CSV. It runs in your browser.

Final drive ratios

FrontRearRatiovs 15/45
15453.000—
14453.214+7.1%
16452.813−6.3%
15483.200+6.7%
15432.867−4.4%

When to use it

  1. Shorten the gearing for quicker acceleration.
  2. Lengthen it to lower motorway revs.
  3. Work out the chain length after a sprocket change.
  4. Correct the speedometer reading after regearing.
  5. Compare several sprocket combinations before ordering.

How to Use

  1. Enter the current front and rear sprockets.
  2. Enter the new sprockets you are considering.
  3. Add primary ratio, top gear, rear tyre and chain size for speed and chain length.
  4. Paste a list of combinations to compare them.

Features

  1. Final ratio and % change
  2. Speed at RPM in top gear
  3. Speedometer error
  4. Chain length in links
  5. 415 to 630 chain sizes
  6. Batch CSV
  7. 100% client-side

FAQs

How do I calculate the final drive ratio?

Divide the rear sprocket teeth by the front. 45 ÷ 15 = 3.00.

Is one tooth at the front the same as three at the rear?

Roughly. With a 15/45 setup, −1 at the front changes the ratio 7.1% and +3 at the rear changes it 6.7%.

How many chain links do I need?

L = 2C/p + (N1 + N2)/2 + p(N2 − N1)²/(4π²C), rounded up to an even number; check the adjuster range.

Will my speedometer be wrong?

Yes, if it reads from the gearbox output or front wheel differently from the rear: the error equals the ratio change.

Is anything uploaded?

No. Everything runs in your browser.

Technical Details

Final drive ratio = rear sprocket teeth ÷ front sprocket teeth. With the primary reduction, top-gear ratio and rear tyre size, road speed per 1,000 RPM = 1,000 ÷ (primary × gear × final) × tyre circumference. Chain length in links L = 2C/p + (N1 + N2)/2 + p(N2 − N1)² ÷ (4π²C) for centre distance C and pitch p (12.7 mm for 415/420/428, 15.875 mm for 520/525/530, 19.05 mm for 630), rounded up to an even number. Batch mode compares sprocket pairs against the current setup.

Calculators & Converters

Calculators & Converters

  • 2-Stroke Fuel Mix Ratio Calculator
  • EV Charging Time and Cost Calculator
  • VIN Decoder and Check Digit Validator
  • Vehicle Running Cost per km Calculator
  • Metal Weight Calculator
  • Beam Deflection and Bending Calculator
  • Bolt Torque and Preload Calculator
  • Tap Drill and Thread Chart