Gravel Calculator

Work out how much gravel to order for a path, driveway, patio base or border. Enter the length and width (or the diameter of a round area) and the depth, choose the type of stone, and the calculator gives the volume and the approximate weight — in cubic meters and metric tons, or cubic yards and US tons. An allowance for compaction is included. It runs in your browser.

Typical gravel densities

Materialkg/m³Metric tons per yd³
Pea gravel~1,500~1.26 US tons
Crushed stone~1,600~1.35 US tons
River rock~1,450~1.22 US tons
Decomposed granite~1,600~1.35 US tons

When to use it

  1. Order gravel for a garden path or driveway.
  2. Work out a sub-base layer under pavers.
  3. Compare a quote by the metric ton with one by the cubic yard.
  4. Estimate how many trips a trailer will take.

How to Use

  1. Pick metric or imperial.
  2. Enter the length and width, or switch to Round and enter the diameter.
  3. Enter the depth and choose the type of gravel.
  4. Read the volume and weight to order.

Features

  1. Volume and weight
  2. Rectangular or round areas
  3. Density presets, editable
  4. Compaction allowance
  5. Metric and imperial
  6. 100% client-side

FAQs

How deep should gravel be?

About 5 cm (2 in) for a decorative path topping, and 10–15 cm (4–6 in) in layers for a driveway, laid over a compacted sub-base.

How much does a cubic meter of gravel weigh?

Usually 1.4–1.7 metric tons depending on the stone and how wet it is. The presets use typical figures; your supplier's number is better if they give one.

Why add extra?

Gravel settles and compacts once it is spread and rolled. The 5% default covers that; raise it for very loose or uneven ground.

Can I calculate a round area?

Yes — switch to Round and enter the diameter.

Is my data sent anywhere?

No. The calculation happens in the page and nothing is transmitted.

Technical Details

Volume is the area multiplied by the depth — length × width for a rectangle, π × (diameter ÷ 2)² for a round area — with everything converted to meters first, so feet and inches work as well as meters and centimeters. An allowance is then added on top, defaulting to 5%, because loose stone compacts once it is raked and rolled, and a delivery that comes up short means paying for a second one. Weight is the volume multiplied by a bulk density, and the density matters more than people expect: pea gravel, crushed stone and river rock sit roughly between 1,450 and 1,600 kg per cubic meter, and the same stone weighs more wet. Presets give typical figures and the density stays editable so a supplier's own number can be used. Results are shown in cubic meters, liters and metric tons, or in cubic yards, cubic feet and US short tons in imperial mode, since suppliers sell by either volume or weight depending on the yard. Everything runs in the page.

Home & DIY Tools

Home & DIY Tools

  • Sand Calculator
  • Mulch Calculator
  • Soil Calculator
  • Paver Calculator
  • Board Foot Calculator
  • AC Tonnage & BTU Calculator
  • Concrete Mix Ratio Calculator
  • Rebar Weight Calculator