Paver Calculator

Work out how many block pavers or patio slabs you need. Enter the area and the paver size, add a waste allowance for cuts, and the calculator gives the paver count plus the volume of bedding sand. Metric or imperial. It runs in your browser.

Pavers per square meter

Paver sizePer m²Per ft²
200 × 100 mm504.6
200 × 200 mm252.3
300 × 300 mm11.11.0
600 × 600 mm2.80.26

When to use it

  1. Lay a patio or garden path.
  2. Pave a driveway with block pavers.
  3. Order bedding sand alongside the pavers.
  4. Compare paver sizes for the same area.

How to Use

  1. Pick metric or imperial.
  2. Enter the area's length and width.
  3. Enter the paver length and width.
  4. Set the waste allowance and sand bed depth, then read the totals.

Features

  1. Paver count with waste
  2. Bedding sand volume
  3. Exact-fit rounding
  4. Metric and imperial
  5. 100% client-side

FAQs

How many pavers per square meter?

For a 200 × 100 mm block, 50 per m². For a 600 × 600 mm slab, about 2.8 per m².

How much waste should I allow?

About 10% for straight and stretcher-bond patterns, 15% for herringbone or areas with curved edges.

How deep should the sand bed be?

3–5 cm (1–2 in) of coarse sand, laid over 10–15 cm of compacted crushed stone.

Do I add a joint width?

Not for block pavers — they butt up with narrow, sand-filled joints. For slabs with wide mortar joints, add the joint to the paver size.

Is my data sent anywhere?

No. Everything is computed in the page.

Technical Details

The number of pavers is the area to pave, increased by a waste allowance, divided by the face area of one paver, rounded up to a whole unit — with a guard so that an exact fit, such as 12 m² of 200 × 100 mm blocks at 10% waste giving exactly 660, is not pushed to 661 by floating-point error. Waste defaults to 10%, enough for edge cuts on a straight or stretcher-bond lay; herringbone and curved edges create more offcuts. Block pavers are laid with tight, sand-filled joints, so unlike tiles no joint width is added to the footprint. The calculator also gives the volume of bedding sand for the area at the chosen depth, typically 3–5 cm, which is laid over a separate compacted sub-base of crushed stone. Units may be metric or imperial. Nothing is transmitted.

Home & DIY Tools

Home & DIY Tools

  • Board Foot Calculator
  • AC Tonnage & BTU Calculator
  • Concrete Mix Ratio Calculator
  • Rebar Weight Calculator
  • Duct Size Calculator
  • Brick and Block Calculator
  • Plaster Calculator
  • Roof Pitch and Roofing Calculator