Transformer kVA and Full-Load Current Calculator

This transformer calculator gives the full-load current on both windings from the kVA rating and voltages, for three-phase or single-phase units. Add the nameplate impedance to estimate the maximum fault current at the secondary terminals. A table shows currents for standard ratings from 15 to 3,000 kVA at your voltages, and you can paste a whole transformer list. It runs in your browser.

Three-phase, 11 kV to 415 V

kVAPrimary ASecondary A
1005.2139
25013.1348
50026.2696
1,00052.51,391
1,60084.02,226
2,500131.23,478

When to use it

  1. Size breakers and cables for a new transformer.
  2. Check a transformer's loading from measured current.
  3. Estimate fault level for switchgear ratings.
  4. Compare standard kVA ratings for a project.
  5. Check a site's transformer list.

How to Use

  1. Enter the kVA rating and phases.
  2. Enter primary and secondary voltages.
  3. Optionally enter impedance %.
  4. Read both currents and fault level; paste a list for many units.

Features

  1. Primary and secondary current
  2. Single and three-phase
  3. Fault current from %Z
  4. Standard kVA table
  5. Batch CSV
  6. 100% client-side

FAQs

How do I calculate transformer full-load current?

Three-phase: kVA × 1,000 ÷ (1.732 × V). A 1,000 kVA transformer at 415 V carries about 1,391 A.

What does %Z mean?

The voltage needed to drive full-load current through a shorted secondary, as a percentage of rated voltage. Lower %Z means higher fault current.

Is the fault current exact?

No. It assumes an infinite supply; source and cable impedance reduce it.

Single-phase transformers?

Choose single-phase and it uses kVA × 1,000 ÷ V.

Is anything uploaded?

No. Everything runs in your browser.

Technical Details

Full-load current = kVA × 1,000 ÷ (√3 × line voltage) for three-phase, or kVA × 1,000 ÷ voltage for single-phase, on each winding. With the nameplate impedance, the maximum secondary fault current ≈ secondary full-load current × 100 ÷ %Z, assuming an infinite source. A table lists currents for standard kVA ratings at the chosen voltages, and batch mode reads a list of transformers.

Electronics Tools

Electronics Tools

  • Room Lighting (Lux) Calculator
  • Electricity Bill Estimator
  • 555 Timer Calculator
  • Op-Amp Gain Calculator
  • RC and RL Filter / Time Constant Calculator
  • PCB Trace Width Calculator (IPC-2221)
  • SMD Resistor Code Decoder
  • dBm, mW and Volts Converter