Hydraulic Cylinder Force Calculator

This hydraulic cylinder calculator works out how hard a cylinder pushes and pulls and how fast it moves. Enter the bore and rod diameters and the system pressure in bar, psi or MPa, and it shows the push and pull force in kN, tonnes-force and lbf. Add the stroke and pump flow to get extend and retract speeds, stroke times and the oil used per stroke. Paste a list of cylinders to compare them. It runs in your browser.

Force at 200 bar

Bore × rodPush kNPull kN
40 × 20 mm25.118.8
50 × 25 mm39.329.5
63 × 36 mm62.342.0
80 × 45 mm100.568.7
100 × 56 mm157.1107.8
125 × 70 mm245.4168.5

When to use it

  1. Size a cylinder for a press or lift.
  2. Check a tipper ram's lifting force.
  3. Work out cycle time from pump flow.
  4. Compare bore and rod options.
  5. Check an existing machine's capability.

How to Use

  1. Enter bore and rod diameters.
  2. Enter the pressure and its unit.
  3. Enter stroke and pump flow for speed.
  4. Read forces, speeds and times; paste a cylinder list.

Features

  1. Push and pull force
  2. bar, psi or MPa
  3. kN, tonnes and lbf
  4. Extend and retract speed
  5. Stroke time and oil volume
  6. Batch CSV
  7. 100% client-side

FAQs

How do I calculate hydraulic cylinder force?

Force = pressure × area. A 100 mm bore at 200 bar pushes about 157 kN (16 tonnes).

Why is pull force lower?

The rod takes up area on that side of the piston, so the same pressure acts on a smaller ring.

How fast will it extend?

Speed = flow ÷ area. 40 L/min into a 100 mm bore extends at about 85 mm/s.

Why add efficiency?

Seals, friction and back-pressure reduce the usable force, typically by 5–10%.

Is anything uploaded?

No. Everything runs in your browser.

Technical Details

Push force = pressure × bore area (π/4 × bore²); pull force = pressure × annulus area (π/4 × (bore² − rod²)), both multiplied by an efficiency for seal friction. Pressure is entered in bar, psi or MPa (1 bar = 0.1 N/mm²). Extend and retract speeds = pump flow ÷ the matching area, stroke times = stroke ÷ speed, and oil per extend stroke = bore area × stroke. Batch mode reads a cylinder list.

Calculators & Converters

Calculators & Converters

  • Pipe Flow and Pressure Drop Calculator
  • Psychrometric Calculator
  • Pump Power and Head Calculator
  • Heat Exchanger LMTD Calculator
  • Welding Heat Input Calculator
  • Weld Metal and Electrode Estimator
  • Coordinate Converter (Lat/Long, UTM, DMS)
  • Plot Area from Coordinates Calculator