ISO Fits and Tolerances Calculator

This ISO fits calculator gives the exact limits for a hole and shaft pair such as H7/g6. Enter the nominal size up to 500 mm and pick the hole and shaft zones — or one of the common fits from loose running to locational interference — and it shows each part's upper and lower limits in millimetres and microns, plus the minimum and maximum clearance or interference and whether it's a clearance, transition or interference fit. Paste every fit from a drawing to check them all. It runs in your browser.

Common fits at 25 mm

FitHole µmShaft µmRange µmType
H9/d90/+52−117/−6565 to 169Clearance
H8/f70/+33−41/−2020 to 74Clearance
H7/g60/+21−20/−77 to 41Clearance
H7/h60/+21−13/00 to 34Clearance
H7/k60/+21+2/+15−15 to 19Transition
H7/n60/+21+15/+28−28 to 6Transition
H7/p60/+21+22/+35−35 to −1Interference

When to use it

  1. Machine a bore for a bearing.
  2. Choose a press fit for a gear hub.
  3. Check a sliding fit on a pin.
  4. Read the limits off a drawing callout.
  5. Teach ISO limits and fits.

How to Use

  1. Enter the nominal size.
  2. Choose hole and shaft letters and grades, or a common fit.
  3. Read the limits and the fit range.
  4. Paste a list of size and fit pairs to check them all.

Features

  1. ISO 286 limits up to 500 mm
  2. IT5–IT11
  3. Shafts d–p, holes D–H and JS
  4. Clearance, transition or interference
  5. Common fit presets
  6. Batch CSV
  7. 100% client-side

FAQs

What is a 25 H7/g6 fit?

Hole 25.000–25.021 mm, shaft 24.980–24.993 mm: a sliding clearance fit of 7 to 41 µm.

Which fit for a press fit?

H7/p6 is the usual locational interference fit; at 50 mm it gives 1 to 42 µm interference.

What does H mean?

The hole's lower limit is the nominal size; its tolerance goes upward by the IT grade.

What is a transition fit?

One that can end up with slight clearance or slight interference, such as H7/k6.

Is anything uploaded?

No. Everything runs in your browser.

Technical Details

Limits follow ISO 286 for nominal sizes up to 500 mm. The tolerance grade width comes from the standard IT5–IT11 values for the size range. Shafts d, e, f, g and h have an upper deviation es from the fundamental deviation table and lower = es − IT; shafts k, m, n and p have a lower deviation ei and upper = ei + IT (k is zero outside IT4–IT7); js is ±IT/2. Holes H, G, F, E and D mirror the shaft deviations (EI = −es) and JS is ±IT/2. Maximum clearance = hole upper − shaft lower; minimum = hole lower − shaft upper; the fit is clearance, transition or interference accordingly.

Calculators & Converters

Calculators & Converters

  • Spur Gear Calculator
  • Pulley and Belt Calculator
  • Spring Rate Calculator
  • Hydraulic Cylinder Force Calculator
  • Pipe Flow and Pressure Drop Calculator
  • Psychrometric Calculator
  • Pump Power and Head Calculator
  • Heat Exchanger LMTD Calculator