Pulley and Belt Calculator

This pulley calculator works out belt drives. Enter the driver and driven pulley diameters, the distance between their centres and the motor speed, and it shows the belt length, driven speed and ratio, belt speed and the wrap angle on the small pulley — for open or crossed belts. If you already have a belt, enter its length to find the centre distance it needs. Paste several pulley sets to compare them. It runs in your browser.

Driven speed from a 1,450 rpm motor

Driver ØDriven ØRatioDriven rpm
100 mm100 mm1.001,450
100 mm150 mm1.50967
100 mm200 mm2.00725
100 mm300 mm3.00483
150 mm100 mm0.672,175

When to use it

  1. Work out the belt length for a new drive.
  2. Change a machine's speed with a different pulley.
  3. Find the centre distance for a belt you have.
  4. Check belt speed against the belt's rating.
  5. Compare pulley combinations.

How to Use

  1. Enter both pulley diameters and the centre distance.
  2. Enter the driver speed.
  3. Read belt length, speeds and wrap angle.
  4. Enter a belt length to find its centre distance.

Features

  1. Belt length, open or crossed
  2. Driven speed and ratio
  3. Belt speed
  4. Wrap angle
  5. Centre distance for a belt
  6. Batch CSV
  7. 100% client-side

FAQs

How do I calculate driven pulley speed?

Driver rpm × driver diameter ÷ driven diameter. A 100 mm pulley at 1,450 rpm drives a 200 mm pulley at 725 rpm.

How do I calculate belt length?

2C + π(D1 + D2)/2 + (D2 − D1)²/4C for an open belt.

What wrap angle is too small?

Below about 120° on the small pulley, belts tend to slip.

Pitch or outside length?

V-belts are sold by pitch, inside or outside length depending on the maker; check which.

Is anything uploaded?

No. Everything runs in your browser.

Technical Details

Open belt length L = 2C + π(D1 + D2)/2 + (D2 − D1)²/(4C); a crossed belt uses (D1 + D2)² in the last term. Speed ratio = D2 ÷ D1 and driven speed = driver speed × D1 ÷ D2. Belt speed = π × D1 × rpm ÷ 60,000 m/s. Wrap angle on the small pulley = 180° − 2 asin((D2 − D1) ÷ 2C). Given a belt length, the centre distance solves the same equation. Batch mode compares pulley sets.

Calculators & Converters

Calculators & Converters

  • Spring Rate Calculator
  • Hydraulic Cylinder Force Calculator
  • Pipe Flow and Pressure Drop Calculator
  • Psychrometric Calculator
  • Pump Power and Head Calculator
  • Heat Exchanger LMTD Calculator
  • Welding Heat Input Calculator
  • Weld Metal and Electrode Estimator